My Drone and Remote Are On, But They Won't Connect

If your Aeroo Pro drone and remote are powered on but not linking together, don't worry ā€” this is usually a simple fix.

Ā 

1. Check That Both Devices Are On

  • Make sure your drone is fully powered up (its lights should be cycling).Ā 
  • Turn on your remote ā†’ the lights will flash while in pairing mode.Ā 

Ā 

2. Pair the Remote to the Drone

If the lights keep flashing, the remote may not be paired.Ā 

Follow these steps to re-pair:Ā 

1. Power on the drone and the remote.

2. On the remote,Ā press and hold the "Payload Release" and "Video" buttons together for 4 seconds:Ā 

  • Listen for a second beep and watch for the lights to flash sequentially.

3. On the drone, press and hold theĀ bind buttonĀ (located on the side under the rubber cover) until the green light starts flashing.

4. Wait 1-2 minutes for the devices to pair.Ā 

  • When pairing is successful, the lights on the remote will turn solid.

Ā 

3. Check for Firmware Updates

  • Connect your phone to theĀ Aeroo FlyĀ app.
  • Go toĀ SettingsĀ ->Ā General PurposeĀ ->Ā VersionĀ to check for any pending updates.
  • Install updates if needed, then try repairing.

Ā 

4. Restart Both Devices

  • Power off both the drone and the remote.
  • Wait 30 seconds, then power them back on and repeat the pairing processĀ 

Ā 

Once paired, youā€™re ready to take off and enjoy smooth flying with your Aeroo Pro!

Back to blog